HiVelocity
09-28-2015, 07:35 PM
Fellow Casters,
I bought this mold on a whim. It looked like it would suffice for a few calibers I already cast and load for.
My problem is, "who developed this configuration?" It has wide grooves, I'm assuming, that are for lubing purposes. Powder coating maybe?
None the less, I already loaded some into 38 Special cases, looks great. Haven't shot them yet. Mine are dropping at .3585-3590. Any information, comments?
HV
~
I bought this mold on a whim. It looked like it would suffice for a few calibers I already cast and load for.
My problem is, "who developed this configuration?" It has wide grooves, I'm assuming, that are for lubing purposes. Powder coating maybe?
None the less, I already loaded some into 38 Special cases, looks great. Haven't shot them yet. Mine are dropping at .3585-3590. Any information, comments?
HV
~