PDA

View Full Version : Load data 9mm



lonewolf5347
09-07-2015, 02:33 PM
any one have any load data on Extreme 135 Gr. F.P. R.N. Copper coated
powder on hand Light Target Loads
Win: 231
Bulleye

straight-shooter
09-07-2015, 05:39 PM
I have chrono results from the Extreme 124 RN using 4.6gr W231. Very accurate load but since your shooting a slightly heavier bullet I would start around 4.4gr

Grains-124

Hi Vel-1015
Low Vel-989
Ave Vel-1000

Ext Spread-26
Std Dev-9

betschet50
09-09-2015, 04:01 AM
I have used 4.4gr of W231 with 124gr lead bullet 1.125orl and it felt like a factory round no pressure issues. for safety always double check your loads with a reloading manual or go to the powder manufacture web for there data. I TRY TO CROSS CHECK AT LEAST THREE TRUSTED SOURCES.

betschet50
09-09-2015, 04:04 AM
Also most plated bullet manufactures recommend using cast lead data.

lonewolf5347
09-10-2015, 03:33 PM
I just got in from the indoor range testing a few 9MM loads
I have drop 4.2 grains win:231 and 135 gr.F.P. R.N. extreme C.O.A.L. 1.145 did a nice group at 15 yards two hand hold un-supported
The next load that really surprise me was 3.7 grains of bulleye and the 135 bullet again same stand at 15 yards did about 1 1/2" not bad for the ruger striker sr9.
I came to a conclusion the sights on the ruger are nice for combat or steel plates but bulleye shooting I wonder id there is something better out there in the way of sights.