True Line Jr

[shtur]

I have been using my only True Line Jr to load .38 special. I would like to know how accurate the repeat-ability is when changing dies between two calibers? I am thinking of loading .45 Auto Rim on the TL Jr .

[Der Gebirgsjager]

If your dies have lock rings with the tiny lock screws on the sides and you tighten the screws a bit and don't move the rings on the die bodies, then it should be very repeatable. Remove the dies by grabbing them above the rings and screwing them out of the press, and return them the same way, but don't move the rings.

[shtur]

Thanks, I'll soon find out how close I can reset the dies.

[Green Frog]

I make up dummy cartridges to use as guides to do the final adjustment whenever I change dies on ANY turret press. Just the way I do things... usually not much adjustment is needed.

Froggie

[s1120]

Ive done the same as GF on my TLjr with 38spc. I make up a dummy round for each projectile I load. Saves a lot of setup time.