Buckshot
10-05-2005, 02:46 AM
http://www.fototime.com/AFAA00BBB05054B/standard.jpg
Checking fit. Front ring of the Krag stuck in the hole. About airtight!
http://www.fototime.com/05DD4E041636E96/standard.jpg
The beginning mill cuts made. Out for check fit.
http://www.fototime.com/1295B50E89293C7/standard.jpg
Almost done. Just a few little touches here and there.
http://www.fototime.com/E802FCD0E8185CF/standard.jpg
Here it is with the action stuck in it. Fitting the lug on the nut to the recess on the bottom of the action.
http://www.fototime.com/BC9C6548FC68881/standard.jpg
This is how far the action stick in the nut. You can see the lug extending back along the action bottom.
http://www.fototime.com/77D4C8B8E6232AD/standard.jpg
The action in place. The slots have been milled in for the binding screws. Still have to cut a slot so the binding screws can pull the nut up tight to the action ring. The front action rings vary by about .005" OD so I figured having the nut able to cinch up a bit would be good.
Checking fit. Front ring of the Krag stuck in the hole. About airtight!
http://www.fototime.com/05DD4E041636E96/standard.jpg
The beginning mill cuts made. Out for check fit.
http://www.fototime.com/1295B50E89293C7/standard.jpg
Almost done. Just a few little touches here and there.
http://www.fototime.com/E802FCD0E8185CF/standard.jpg
Here it is with the action stuck in it. Fitting the lug on the nut to the recess on the bottom of the action.
http://www.fototime.com/BC9C6548FC68881/standard.jpg
This is how far the action stick in the nut. You can see the lug extending back along the action bottom.
http://www.fototime.com/77D4C8B8E6232AD/standard.jpg
The action in place. The slots have been milled in for the binding screws. Still have to cut a slot so the binding screws can pull the nut up tight to the action ring. The front action rings vary by about .005" OD so I figured having the nut able to cinch up a bit would be good.