WyrTwister
03-16-2008, 02:20 PM
This rifle has been converted to .357 Mag .
I am working on some .357 brass . Will experiment with different seating debths to try to optimize feeding .
Last time I was casting bullets , I used my SWC mold to cast some .357 / .38 bullets .
Realizing this bullet shape is not optimum for a lever gun , I am going to see how well I can get it to feed , by tiring to fine tune the OAL .
If this does not work out , I will probably order a Lee 6 cavity RN mold .
God bless
Wyr
I am working on some .357 brass . Will experiment with different seating debths to try to optimize feeding .
Last time I was casting bullets , I used my SWC mold to cast some .357 / .38 bullets .
Realizing this bullet shape is not optimum for a lever gun , I am going to see how well I can get it to feed , by tiring to fine tune the OAL .
If this does not work out , I will probably order a Lee 6 cavity RN mold .
God bless
Wyr