NOE 360 155Gr Wadcuter/432 230gr WC

[Thomas Traddles]

I'd like to get a multi-cavity high quality wadcutter mold. I've read good things about NOE's products and have been considering the two mentioned in the thread title. Does anyone have any experience with either of these two molds? I would appreciate hearing your thoughts. Thanks.

[RedHawk357Mag]

Have them both in four cavity. I like them a lot. Shoot a lot of them with variety of loads and powders. If my molds were stolen or got used for hammers I would replace both that day. Noe molds are excellent.

[RedHawk357Mag]

Probably could send 25 or so to check them out. Mine are range scrap plus a guesstament of monotype for 2 percent tin. I use the lead calc that you find on here to mix my alloy. They have Randy Rat green TAC for lube.

[Thomas Traddles]

Redhawk357, thank you for the reply and the offer. The kindness of folks on this board never ceases to amaze me. I will take you up on your offer of a few samples. I've sent you a PM. Thanks.

[rintinglen]

I only have the 432-230 WC, but in a 5 cavity. I really like this mold. I have shot quite a few and out to 50 yards they are very accurate over 5,5 grains of Unique or 4.5 grains of Red Dot. at about 70 yards they begin to spread out and by the time they get to 100 yards they are shooting groups the size of a wash tub, but out to 50 yards, they are the cat's meow.