Looking for a good 32 S&W Mold/ Load

[shootinfox2]

Title says it all. I am looking for a good mold for 32 S&W for cowboy action shooting.
Close range derringer 0-2 YDS, and pocket pistol 2-5 Yards out of a S& W top break pistol.Thanks in advance.

Fox

[Tar Heel]

I use the Accurate Mold 313110B over 2gr of 231.

It's the cartridge on the right. The one on the left is a 32-20 with the Accurate Mold 313120B. Link to the bullet is below:
http://www.accuratemolds.com/bullet_detail.php?bullet=31-110B-D.png

132260


(http://www.accuratemolds.com/bullet_detail.php?bullet=31-110B-D.png)

[Outpost75]

If loading the. 32 S&W, NOT the "Long" use Accurate 31-087T and 1.2-1.5 grains of Bullseye.

[shootinfox2]

Thanks for the replys. Will look at both.
Fox

[Tar Heel]

The load I stated is for the S&W LONG. Thanks Outpost75.....

[10mmShooter]

I use the RCBS 32-98-SWC....a nice little SWC for the .32 I size to .314 in my old 1920 "I" frame SW Long and my 32-20 in my early "K" frame .32-20.

[pworley1]

I like the Lyman 311252 over 1.2g of Bullseye for the Short, and the Lyman 311227 over 1.7g of Bullseye for the long.

[rking22]

For cowboy shooting ,I think you shoot lots of them right? I have a 6 Hole Lee 93 gr that actually casts at .314, shoots well in my M31-1. It is listed as a 311 mold I believe, don't know if they all run big but mine does.

this one
http://www.titanreloading.com/molds/bullet-molds/32-20-32-sw-long-32-colt-np/lee-6-cav-mold-311-93-1r-

[35remington]

My Lee 93 grain does not cast that large. For revolvers it would be undersized.