Powder Charge Stand

[Ben]

I use a good bit of 2400 ( I hope I can continue to find it in the future ? ), One of my favorite loads in my 30-06 is 17.2 grs. of 2400 with 150 - 220 gr. cast bullets.

I ordered an RCBS Little Dandy Rotor that throws 17.2 grs. of 2400 , dead nuts on, every throw. PERFECT ! ! !

At one time I had my powder measure off to my right, I continued working back and forth . I guess I'm a slow learner. Eventually it dawned on me that I needed to relocate my powder measure .

About 20 minutes of work on my radial arm saw and drill press and I ended up with a powder measure stand that meets my needs very well. It is assembled with wood glue and long air nails. It will clearly outlast me !

I really like my set up now.

Quick , safe and very easy to use.

Ben

http://i1155.photobucket.com/albums/p545/Ben35049/007_zps3eb80262.jpg (http://s1155.photobucket.com/user/Ben35049/media/007_zps3eb80262.jpg.html)

http://i1155.photobucket.com/albums/p545/Ben35049/014_zps9562b4c1.jpg (http://s1155.photobucket.com/user/Ben35049/media/014_zps9562b4c1.jpg.html)

http://i1155.photobucket.com/albums/p545/Ben35049/008_zps9cc07910.jpg (http://s1155.photobucket.com/user/Ben35049/media/008_zps9cc07910.jpg.html)

http://i1155.photobucket.com/albums/p545/Ben35049/009_zpse9b8b211.jpg (http://s1155.photobucket.com/user/Ben35049/media/009_zpse9b8b211.jpg.html)

If for any reason, I need to move the powder measure stand, I can take my cordless drill and remove 4 screws and it is out of the way.

http://i1155.photobucket.com/albums/p545/Ben35049/011_zps6da3b977.jpg (http://s1155.photobucket.com/user/Ben35049/media/011_zps6da3b977.jpg.html)

Here I am loading some 06' with 17.2 grs. of 2400 with my IDEAL 31141 HPs. I really like this set up.

http://i1155.photobucket.com/albums/p545/Ben35049/013_zpsc125b5b4.jpg (http://s1155.photobucket.com/user/Ben35049/media/013_zpsc125b5b4.jpg.html)

Ben

[LUBEDUDE]

As usual you got it going on Ben. Looking Good!

[Ben]

I get lucky sometime.......................