I need to Size some Bollits to .359-.360

[twotrees]

I just checked the sizing die supply nad don't have on that size.

BUT, I do have 2 .357's. Could you lap one out to .360? and If you did would you need to make a new plunger to keep the lube from running out?

Yea, I'm Scottish and moths fly outa my wallet, if and when I open it.

Would save some time getting one in, IF this can be done.

WhatCa' Thimk???


TwoTrees

[dubber123]

I have honed quite a few dies .002" or more, if I don't crank the pressure on the luber up too high, lube seepage around the pin doesn't seem too bad.

[Mugs]

Like dubber says I've honed a .285 to .286 and a . 357 to .3595 with no problems.
Mugs