Patrick L
01-11-2015, 04:08 PM
The pin that holds the block to the handles on my Group Buy MiHec 22 NATO mold broke when I was taking the mold off the handles today. Really odd, the pin just sheared off above the threaded portion. I've been casting with this mold all winter with no problems, and was just putting it away for the season.
I'm sure I didn't over tighten it, plus you think if I did it would have done that back when I put it on the handles a few weeks ago.
Anyhow, how do I go about getting a replacement?
I'm sure I didn't over tighten it, plus you think if I did it would have done that back when I put it on the handles a few weeks ago.
Anyhow, how do I go about getting a replacement?