View Full Version : what is this die for???
Mach_Cat
12-31-2014, 01:58 PM
threaded both ends. no name on it. bottom a little larger than the top. Is this for swaging?
125850125852
IllinoisCoyoteHunter
12-31-2014, 02:35 PM
Could it be used to swage lead wire?
Mach_Cat
12-31-2014, 02:45 PM
it is threaded all the way through. no smooth area inside for swaging.
IllinoisCoyoteHunter
12-31-2014, 02:56 PM
hmmmm....
garandsrus
12-31-2014, 03:24 PM
It looks like a punch holder for Corbin swage presses.
You can see it on this page: http://www.corbins.com/csp-1.htm
Mach_Cat
12-31-2014, 04:40 PM
I think the Corbin is correct. I have 3 mighty mites so it must go with those. Will throw it in the box for the current buyer.
midnight
12-31-2014, 05:12 PM
I think it is a floating punch holder for the Mity-Mite. Dave Corbin said that the shorter punch holder like you have is used on the Mity-Mite but the "S" punch holder works as well even though it is a little longer.
Bob
aaronraad
01-05-2015, 08:18 PM
Do both the bushes have their ID's threaded as well?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.