View Full Version : MP molds .380 acp hollow point mold
Tom_in_AZ
12-09-2014, 12:28 AM
Have this mold on it's way. Hoping to develop a nice load for my Ruger LCP. Anyone have experience with this bullet in an LCP/Bodyguard or similar?
TIA
Tom
DR Owl Creek
12-09-2014, 01:22 PM
From looking at the Active Group Buys threads, it appears that this buy hasn't closed and gone into production yet.
Dave
gtgeorge
12-09-2014, 02:56 PM
I too wondered about that since it is over 2 years old and still going.
Mihec ran a .380 hp mold years ago that is different design than what is currently active in the group buy section.
dragon813gt
12-09-2014, 03:28 PM
Helps to post what mold number it is. Takes away all confusion.
This the mold you have OP?
http://mp-molds.com/shopping/pgm-more_information.php?id=9&=SID
Tom_in_AZ
12-10-2014, 12:55 PM
Yes dkf, that's the one
Tom_in_AZ
12-10-2014, 12:56 PM
Helps to post what mold number it is. Takes away all confusion.
No mold number listed.
dragon813gt
12-10-2014, 01:10 PM
No mold number listed.
It should be engraved on the mold. I don't have any from him that aren't engraved.
Tom_in_AZ
12-10-2014, 08:27 PM
As I said in the first post, it's on it's way. I will post the number when I receive it.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.