Case trimmer

[SwedeNelson]

Had some 348 Win. brass to trim down for .41 Swiss
Used my 1200 Lb Case trimmer

http://i69.photobucket.com/albums/i80/swedenelson/Picture246.jpg

Lee Case Spindle with drill shank and
Lee Universal 3 Jaw Chuck
Worked good after I got it dialed in.

http://i69.photobucket.com/albums/i80/swedenelson/Picture247.jpg

Swede Nelson

[Lucky Joe]

It's amazing what you guys can do with that stuff.

[cbrick]

I built my own lathe for that very purpose, it does everything the Forster does cept far faster, also does chamfering, primer pockets and flash holes. The top of this photo was cropped off but the curved black shaft on the right side of the machine is a flex work light. It has 5 output shafts with 4 different shaft speeds, two motors, chain and gear drives and operates on both 110v and 12vdc.

http://www.lasc.us/2006-05-25.jpg

[HotGuns]

cbrick...

that is exellent. Got any more pics?

[dnepr]

If I have a bunch of cases to do in a hurry I will mount my lee case trimmer and appropriate mandrel in the lathe . but most time I do them by hand while watching the boob tube. I had some .357 cases that were really long but even my little southbend made short work of them.