Mach_Cat
11-25-2014, 07:04 PM
Have two ROAs One came with a R&d 45LC conversion cylinder.
On the instructions for fitting a cylinder the R&d says you might need to remove a small amount on the
forward part of the frame.
Why would you rework the frame? Seems like you should remove a small amount from the front of the cylinder instead. (where the pin goes through)
If you remove from the frame then that would mean the original cylinder would be just a little sloppy for and aft.
Thoughts?
the cylinder currently fits one ruger but not the other.
On the instructions for fitting a cylinder the R&d says you might need to remove a small amount on the
forward part of the frame.
Why would you rework the frame? Seems like you should remove a small amount from the front of the cylinder instead. (where the pin goes through)
If you remove from the frame then that would mean the original cylinder would be just a little sloppy for and aft.
Thoughts?
the cylinder currently fits one ruger but not the other.