NOE 402-150-hp anyone using this boolit?

[tazman]

I am considering getting this mold. Does anyone have any experience with it?
Any input is appreciated.

[RED333]

Not the NOE, but I do have the MP mold.
Great boolit design, NOE makes a great mold, ya just cant go wrong.

[tazman]

I am curious about how well this boolit performs in the 40S&W.
Is anyone using it at all?

[RED333]

The design works great in all 7 of the Glocks we have.

[tazman]

That is good to hear. What diameter are you sizing them to?

[Ia.redneck]

I use the MP hp version in a Glock 23. It's a little better grouper than the Lee 175 swc tl or their 140 swc.
I use a mild load of 4.5 W-231 and size to .402. It feeds and functions fine in the stock barrel.
Just got one of those improved slide locks from King Glock (smaller, tighter lockup slot) but haven't tested it yet.

[harley45]

I use the MP version in 10mm at about 1000 fps as a light recoiling target and plinking load so the kids and wife can shoot my gun. at that velocity range it is accurate and all of us can shoot it all day!

[RED333]

I size to .401 and powder coat, Titegroup powder is the push I use.

[sargenv]

I use the 160 gr RN version of this one (HP is the 150). My cast comes out right at 158 gr. It shoots nice.. I use it for USPSA and ICORE revolver shooting.. also have used it for Limited division.

[tazman]

This is exactly the kind of information I was looking for. I only need one more mold in a weight lighter than 175 to complete the range for my 40 cal.
It sounds like this may be the one.