View Full Version : Getting brass press ready in volume
monmouth
10-21-2014, 11:54 PM
Trying to increase volume, decrease time, and delivery press ready brass. This weekend, I was fooling around with some "polishing mixes" for volume that's cost effective and my friend liked my setup. Thought you guys may enjoy it as well
http://youtu.be/bDuE5-yegqc
W.R.Buchanan
10-24-2014, 07:30 PM
If I were to get into the used brass business that's how I'd do it. I would really like to have one of those pretty Lowes Cement Mixers with the plastic drum but I don't have an immediate use for one. I am not your competition.
Randy
monmouth
10-31-2014, 07:38 AM
If I were to get into the used brass business that's how I'd do it. I would really like to have one of those pretty Lowes Cement Mixers with the plastic drum but I don't have an immediate use for one. I am not your competition.
Randy
its a good mixer and does the job well. Going to buy another one soon.
jmorris
10-31-2014, 09:58 AM
I built a few of these for a remanufacturing business. They wet tumble and use a gantry crane to load and unload them.
https://www.youtube.com/watch?v=GlZOYjmAnO0
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.