aprayinbear
10-10-2014, 01:23 PM
While I've not been casting bullets as long as some of you folks, I have been "rolling my own" for over 5 years in a variety of calibers for both handguns and rifles. So far, all of my molds have been Lee molds and I have found them to work well.
That was until I ordered my Lee 405 Grain .457 mold. As usual I cleaned the new mold, smudged the mold with a lighter and used a bit of bees wax to lubricate the pins and sprue cutter screw. I want to use this bullet for black powder loads to be used in a Springfield Trapdoor. Problem is, I couldn't get a truly round bullet from the mold. I probably tried 100 times or more before calling Lee and agreeing to send it back for replacement or repair. Of course I had to pay the shipping to send the mold back.
I received the mold yesterday (a new mold), prepped it last night and tried again today. Same problem! here's a pic of what I'm talking about ...
http://i50.photobucket.com/albums/f341/aprayinbear/IMG_1167_zps297f322d.jpg (http://s50.photobucket.com/user/aprayinbear/media/IMG_1167_zps297f322d.jpg.html)
As you can see the two halves are way out of true.
What's up? Suggestions? Am I missing something or is Lee missing the target on this one.
Help:(
That was until I ordered my Lee 405 Grain .457 mold. As usual I cleaned the new mold, smudged the mold with a lighter and used a bit of bees wax to lubricate the pins and sprue cutter screw. I want to use this bullet for black powder loads to be used in a Springfield Trapdoor. Problem is, I couldn't get a truly round bullet from the mold. I probably tried 100 times or more before calling Lee and agreeing to send it back for replacement or repair. Of course I had to pay the shipping to send the mold back.
I received the mold yesterday (a new mold), prepped it last night and tried again today. Same problem! here's a pic of what I'm talking about ...
http://i50.photobucket.com/albums/f341/aprayinbear/IMG_1167_zps297f322d.jpg (http://s50.photobucket.com/user/aprayinbear/media/IMG_1167_zps297f322d.jpg.html)
As you can see the two halves are way out of true.
What's up? Suggestions? Am I missing something or is Lee missing the target on this one.
Help:(