358 Winchester brass

[Bjornb]

I was on the receiving end recently, member Monge sent me some short cases for my 45-70 Guide Gun, and he didn't want any money. So, to pass on a favor, I have 147 pieces of fully prepped, once fired cases converted from 7.62x51 (TAA 09 headstamp). I am standardizing on LC brass so this was just sitting on the shelf. FL sized in an RCBS 358 Win sizing die, trimmed, chamfered and deburred, primer pockets cleaned. Just post here that you want the brass and I'll get it out to you. It fits in a jammed full SFRB.

[brstevns]

I could use those

[Bjornb]

You got'em.
Mods please close thread. It's already been open 25 minutes!

[BrassMagnet]

Helping Hands move fast!

[Bjornb]

Helping Hands move fast!

That's true Ron.

[brstevns]

I think it best if I past on these. Sure there is someone that can use them more then me

[KLR]

I'd like them if they are still available. Thanks.

[Bjornb]

OK KLR, PM me your address so I can get them ready.