PDA

View Full Version : 223 with cast



jason f
09-12-2014, 04:01 PM
http://noebulletmolds.com/NV/product_info.php?cPath=24&products_id=934

using this noe 225 45 grain pb bullet. looking for about 12-1500 fps. looking for a starting point. thanks jason

brstevns
09-12-2014, 04:45 PM
5.0gr Unique will be very close to that FPS

chsparkman
09-12-2014, 07:20 PM
I use 5-5.5 grains of Green Dot for similar velocities. Very clean and accurate in my Ruger #3.

runfiverun
09-13-2014, 12:12 AM
if you have a faster powder than green dot [like red-dot] drop the load down to 4 grains.
about 9 grs of 2400 will get you there too.

blackpowder man
09-14-2014, 11:35 PM
Seems like I used 6.0 grains of Unique with the 44 grain lyman 225438, but the speed was faster than you are looking for.

beezapilot
09-16-2014, 04:34 PM
Just back from the range, new rifle, scope & learning .223 loads.

Loaded Lyman 225415 (55 gr/ w gas check) with 5.5 grains of Promo (poor mans Red Dot), seemed a very consistant low power load (lowest in the Lyman manual), grouped in at about 2 inches... leaning against a post.

The problem I had is not related to the load... while the group was OK for semi offhand, the scope would not adjust...

Dang.

JWFilips
09-16-2014, 05:21 PM
I shoot a 46 gr boolit with 3.0 grain Bullseye Should be somewhere in your velocity requirement Just lube twice with LLA. Get about 1" at 50Yd groups but then again mine are GC boolits without the gas checks. I Bet a PB boolit would do better.
Like shooting 22 longrifle