6mm Cotter

[gunshot98]

I have a question about some dies i have. 6MM Cotter. Are they a wild cat load. Just don't know much about them and i want wisdom from the mass's here. Thanks

[gwpercle]

You got a rifle to go with them dies or just dies? It is a wildcat, based , if memory serves me right, on the 22-250 Remington necked up to 6mm. I don't know if any changer were made to the case such as straightening out body taper or changing shoulder angle. You don't see to many of these.
Gary

[gunshot98]

Thanks Gary, I don't have the rifle, just got the dies in a buy-out. Don't really know what i'm going to do with them. I just thought Cast Pics might have some info on it . Thanks again. Steve

[wolf3006]

Bill Cotter used a 300 magnum case to make this. The case is 2.2 inches long, has a 30-degree shoulder, and a neck length of 3/8 inch, and uses the standard 300-magnum body taper. Will this fit your die?

[gunshot98]

I don't know if it will but when i get home in the morning i am going to try it and see. i will let you know. Thanks for the info.