MtGun44
07-22-2014, 01:15 AM
Anybody have a .45 ACP chamber reamer? I'm in the unfortunate position of
having needed to shorten the hood and rear face of a 1911 barrel enough to fit
a fairly short-built (no name) slide that I now need to slightly deepen the chamber!
Probabaly only need to deepen by .010 or .015 at most, need a few twists with
a finish reamer.
PM me if you have one that you'd rent or loan.
Thanks.
Bill
having needed to shorten the hood and rear face of a 1911 barrel enough to fit
a fairly short-built (no name) slide that I now need to slightly deepen the chamber!
Probabaly only need to deepen by .010 or .015 at most, need a few twists with
a finish reamer.
PM me if you have one that you'd rent or loan.
Thanks.
Bill