Best Nipples for Ruger Old Army?

[pkie44]

I recently acquired a used Ruger Old Army, nipples are a bit buggered from previous owner. I got the nipples out and need to replace them, what is the best nipples to use?
Thanks

[Outpost75]

I replaced mine with Uncle Mikes. I'm not sure if they are still available because I cannot find them on their web site to send you a link, but I contacted them via webmail and when they answer I will post the info here. Enjoy your fine revolver.

[dondiego]

Track of the Wolf recently had nipples and wrenches for the ROA on sale. I just now loaded mine up along with an 1851 and am going outside to make some smoke!

[pkie44]

I found a couple of options. Treso and Uncle Mikes, any advantage with the smaller flash hole in the Treso nipples?

[koger]

I always used the factory ones, should still be available, with no issues at all.

[waksupi]

I found a couple of options. Treso and Uncle Mikes, any advantage with the smaller flash hole in the Treso nipples?

Hotter spark.

[FLHTC]

I believe i have a new in the package, set of Uncle Mikes nipples for the OA if you're interested.

[FLHTC]

Hotter spark.

The cap compound controls the heat, the hole controls the reach into the cylinder.

[rodwha]

Track of The Wolf's nipples use the same hex head wrench (or 3/16 nut driver/socket), and are externally the same as the ROA, but internally they are like the TRESSO's. They claim to be sized to use CCI #11's, which I cannot find, but found the magnum variety often take two strikes. However Rem #10's work very well. They are also slightly cheaper than the TRESSO's.

I replaced mine only because the Rem #11's needed pinching, and the CCI #11 mags also took two strikes.

[drago9900]

I thought CCI made Remington caps, maybe CCI 10's will work. Anyone know whose nipple will hold a RWS 11. I have those caps and a under-hammer target pistol with a Ruger nipple.

[Tar Heel]

Track of the Wolf. Period.

Nipple, 12-28 thread, for Ruger Old Army revolver, #11 CCI cap, stainless steel, for Ruger hex socket or Track's #NW-130 wrench

http://www.trackofthewolf.com/List/Item.aspx/807/1?PageSize=100

[waksupi]

The cap compound controls the heat, the hole controls the reach into the cylinder.

The smaller hole directs the flame into a more concentrated area. Kind of like screwing down the nozzle on a hose.

[Tar Heel]

I always used the factory ones, should still be available, with no issues at all.

Now there's a thought.

[rodwha]

CCI makes the Winchester caps.

[rodwha]

My factory nipples didn't give me issues. I only changed them as I couldn't get Rem #11's or CCI #11 mags to work well.

I have kept the factory nipples since there is nothing wrong with them.