Cylinder reamer needed

[.429]

Is there someone on this site that I could send my gp100 cylinder to for a reaming job? I'm needing to size my boolits to .358" and when used in .357 brass they are snug (38spl with .358" works just fine). When I size to .357 they drop in better, but I get leading. Thanks

[DougGuy]

PM sent

[gray wolf]

DougGuy

I think I need the same PM, need to go from .3575 to .358
Great face book page, But I do ot see any info for 357 cylinders ?

[Beerd]

going up .0005" is a diy project. somewhere on this vast internet (beartoothbullets?) is a step by step tutorial using an electric drill and wet/dry sandpaper.
..

[jmort]

An non-firearm reamer and a Vice Grip
http://www.beartoothbullets.com/tech_notes/archive_tech_notes.htm/72

Sand paper and a drill press
http://www.beartoothbullets.com/tech_notes/archive_tech_notes.htm/71

[gray wolf]

Thank you men, I WILL check it out.