View Full Version : I am stumped, what the heck is this?
Char-Gar
05-31-2014, 11:02 PM
I picked up an older set of Lyman dies for the Tru-Line Jr. There are NIB. The sizing die and seating die fit the 38 S&W just fine. The expander is marked .386 but measures .385. The nominal bullet size of the 38 S&W is .361. The nominal diameter of the S&W case neck is .3855. I don't think it is likely a 38 S&W case expanded and bullets .385/.386 would chamber.
I am clueless about what I have. Any ideas?
texassako
05-31-2014, 11:19 PM
My first thought was an expander for .38-40 got mixed in, but seems a bit small for that.
flyingmonkey35
05-31-2014, 11:30 PM
What you got their is a piece of history.
did they cost you much?
Scoutdog99
06-01-2014, 01:49 AM
I believe an expander marked 386 is for a 41 Long Colt.
Guesser
06-01-2014, 09:19 AM
+1 on the 41 Colt.
Call Lyman they may have the part you need. I bought an old 9mm set that had the TC seater and they sold me a RN seater for something like $7.
MtGun44
06-01-2014, 11:25 AM
AH! Heeled boolit! Amazing, guys. I was wracking my brain, couldn't imagine
what was about a .390 or so boolit diam - so not the boolit, the heel.
Bill
Three44s
06-01-2014, 01:28 PM
If Bill is right and he usually is ............ you have a new mission!
Find a mold to make heeled bullets ........
............ it never ends!!
Three 44s
Wayne Smith
06-02-2014, 02:00 PM
I have the mold, I may have the gun fixed since I blew it up, and I would suggest that you call the 310 shop and get the proper expander unless you want a set for the 41 Colt!
runfiverun
06-02-2014, 03:22 PM
I don't think you push it all the way in, you just use it to flair the case mouth.
Char-Gar
06-02-2014, 03:30 PM
I think somebody at Lyman screwed the pooch when they were labeling and boxing the dies. I believe the expander is indeed for the heeled bullet in the 41 Colt round.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.