Magnetic Strip To Hold Necessaties...

[BCB]

Seems there are lots of tools that are needed to setup various brands of dies…

I got tired of running to my tool chest and getting the wrenches, plies, screwdrivers, etc. that I needed when changing dies or readjusting…

So, I purchased a magnetic strip and hooked it to the reloading bench. The tools are there now. Right beside my RCBS press…

Too bad that Iron City Beer Company doesn’t use steel cans anymore!!!...
(Maybe they do, but I just haven’t had any “Iron” for a good many years!!!)…

I think winter has finally beat me…

BCB ----------------- GO BUCS…

[Mk42gunner]

The ones I miss are the old Hamm's Draft cans that were shaped like a keg. My uncle hauled Hamm's and later Olympia from St Paul to Kansas City for years, so we saw a lot of those cans when I was a kid.

Robert

[w5pv]

Nice set up,mine is similar but uses cup hangers.

[largom]

I use peg-board behind my bench.

Larry

[mannyCA]

These magnetic strips work very well with knives, mags, slides etc. Endless possibilities.

[Hardcast416taylor]

I bought some longer mag strips for my barn but wound up putting a 2` length over my melting table to "stick" my most used molds to.Robert