Moonman
04-11-2014, 12:43 PM
I took the Vibra-Prime tube and placed it into my RCBS Bench Mount Automatic Primer.
IT FIT, YEA!
I have my RCBS unit mounted to a board that I move around and C-Clamp at
different areas to do priming work sometimes.
The quick change retaining pin is too low on the Vibra-Prime unit to work with the RCBS unit,
so I redrilled a 1/16" hole for it 3/8"-1/2" above the existing hole in the Vibra-Prime tubes.
I left the WINGED CONNECTOR on the Vibra-Prime tubes.
Insert the retaining pin into the new hole, fill the Vibra-Prime tube with primers,
Remove tube from the Vibra-Prime unit and place into the
RCBS Automatic Bench Primer Seater, pull the retaining pin and start priming.
I like it, bought 2 more Vibra-Prime units on the MIDWAYUSA $25 sale.
MOONMAN
IT FIT, YEA!
I have my RCBS unit mounted to a board that I move around and C-Clamp at
different areas to do priming work sometimes.
The quick change retaining pin is too low on the Vibra-Prime unit to work with the RCBS unit,
so I redrilled a 1/16" hole for it 3/8"-1/2" above the existing hole in the Vibra-Prime tubes.
I left the WINGED CONNECTOR on the Vibra-Prime tubes.
Insert the retaining pin into the new hole, fill the Vibra-Prime tube with primers,
Remove tube from the Vibra-Prime unit and place into the
RCBS Automatic Bench Primer Seater, pull the retaining pin and start priming.
I like it, bought 2 more Vibra-Prime units on the MIDWAYUSA $25 sale.
MOONMAN