armednfree
04-08-2014, 09:28 AM
I probably have a different way, I don't know. I have this Texas H press, old one. I have a lube pad that I put alox in, which I thin with mineral spirits. I put three drops of mineral spirits in it before I start. I roll the boolit on the pad then put on the gas check. Then I put it between the halves of the press and bump it on. I check it to see if it's evenly seated, if its not that is a slight burr on the bullet shank. Pop it back off and take a pen knife and scrap away that burr. Put it back on, check it them run it through the sizer. I wear latex gloves and build up lube on my fingers, enough that I can lube a few bullets just by rolling them between my fingers.
Yeah, I'm a bit picky on this. Maybe I take QC a little far, but I make good boolits. I'm even more picky when I make hunting loads.
101780
Yeah, I'm a bit picky on this. Maybe I take QC a little far, but I make good boolits. I'm even more picky when I make hunting loads.
101780