Lee .45 mold??

[leadhead]

Any one shoot the Lee 200 gr RF bullet in there 1911, and if so,
how did it shoot? Thanks for any info.
Denny

[dubber123]

It is what my brother uses in his carry ammo, I cast them, and my copy of that mold runs 215 grains. The nose is very short, and others have had feed issues in their semis, you will have to try it and see. I only tested them much in a 625 revolver, (acp), and it's an accurate design. 2.5" at 50 yds. with no real load development.

[CastingFool]

I tried it in my .45 Highpoint, and it doesn't feed well. Shoots fine out of my RBH. I tried other cast boolits (commercial) in the Highpoint, and had the same issue. Does fine with jacketed.

[dmize]

They feed fine out of my Kimber and SR1911 and also out of the Taurus PT1911 when I had it.

[ravelode]

Works like a champ in my Springfield XD, (mine is an older one that chokes on SWC of any type). My experience is it casts 211 grains. My two cavity is worn plumb out after 10,000 boolits (not to shabby for a $16.99 mold)

[Cmm_3940]

Some info in this thread:

http://castboolits.gunloads.com/showthread.php?232229-Lee-200-gr-452-FP