miker557
03-27-2014, 09:35 PM
I picked up one of these molds week before last to cast some 330 grain hollow points to load 45-60 with, and this past Sunday I finally warmed up the lead pot and got them cast. After sizing and lubing them, I noticed two things: (1) the hollow point is noticeably off-center, and (2) the bullets (which were cast of wheel-weight material) weigh in at around 350 grains.
Has anyone else had experience with this mold, and what kind of results have they gotten?
Also, I sent a message to Lyman two days ago explaining my experience - so far I have not heard from them. Has anyone else on this forum dealt with their customer service, and if so, what kind of experience did you have?
Miker
Has anyone else had experience with this mold, and what kind of results have they gotten?
Also, I sent a message to Lyman two days ago explaining my experience - so far I have not heard from them. Has anyone else on this forum dealt with their customer service, and if so, what kind of experience did you have?
Miker