LEE-Menting!!

[NSP64]

I read the posts here and applied them to a lee .429 mold, using toothpaste and two boolits each time I was able to 'lap' it open to .4305 so I can size to .430.:Fire: This site is GREAT!

[hunter64]

I have done it with comet cleanser and opened a .309 lee bullet to .310. I took a while but I worked slow and in the end it was worth it. Lots of info on this site and boy am I glad I found it last year.

[NSP64]

AMEN! I used crest and would hand turn them. I used two bullets in their cast cavities and then would clean,heat mold. recast 2 new ones for each cavity and do over. about 6 hrs total but well worth it. I cast some this AM and they just fall right out, and are more uniform then before.:-D