osteodoc08
02-22-2014, 09:21 PM
Next time I'm home, I will be grabbing my late father's LAM 2 as well as the sizing dies, some of he more common molds I use, one of his pots, smelting set up and a few hundred pounds of COWW.
I'd like to clean up the LAM2. It's covered in gunk and lube that has junk all in it, etc. I intend on spiffing it up and putting it to use. RandyRat offered me a small sample of TAC1 and when I run out of LBT Blue I'm gonna try it. Ideas for getting it all out and cleaning the entire press? Best way to clean the sizing dies? I've got a 1.5L Lyman ultrasonic as well to use.
The Lee Pots have oxidation all over the sides and maybe an inch of Lead in the bottom. I've seen the posts and recommendations on cleaning them out, but is it worth it? Last bullets I cast were fine.
Kinda nervous on smelting by myself. I always let him do it while I cast.
Let the games begin!
I'd like to clean up the LAM2. It's covered in gunk and lube that has junk all in it, etc. I intend on spiffing it up and putting it to use. RandyRat offered me a small sample of TAC1 and when I run out of LBT Blue I'm gonna try it. Ideas for getting it all out and cleaning the entire press? Best way to clean the sizing dies? I've got a 1.5L Lyman ultrasonic as well to use.
The Lee Pots have oxidation all over the sides and maybe an inch of Lead in the bottom. I've seen the posts and recommendations on cleaning them out, but is it worth it? Last bullets I cast were fine.
Kinda nervous on smelting by myself. I always let him do it while I cast.
Let the games begin!