Wayne S
02-13-2014, 11:38 AM
Never mind, decided to just put the $$ in a MADE IN THE USA mold that the Specs. are listed in the drawings for the GB
.
.
I have a 6 cavity brass mold that is (+ -) .0025 undersized. I've tried "beagleing" with one then both sides with tape, and end up with castings .003 out of round. An H&I die will take care of the bands BUT there still is the nose.
I'm thinking about sending it to Eric to have two cavities opened up and a .220 D D band put into the nose.
Logic would say do cavities 3 & 4 thus leaving # 1&2 and # 5 & 6 open for equal heat
?????
.
.
I have a 6 cavity brass mold that is (+ -) .0025 undersized. I've tried "beagleing" with one then both sides with tape, and end up with castings .003 out of round. An H&I die will take care of the bands BUT there still is the nose.
I'm thinking about sending it to Eric to have two cavities opened up and a .220 D D band put into the nose.
Logic would say do cavities 3 & 4 thus leaving # 1&2 and # 5 & 6 open for equal heat
?????