Forrest r
02-10-2014, 09:14 PM
I've been wanting to make a light hbwc bullet for the 9mm. Got a mold awhile back that had a bubba job done to it so I figured it would be a good canidate to get bubba'd a little bit more.
The bullet has 3 drive bands & a .357 tail, figured the bullet would get swaged down no matter what when it's hollow base is seated deeply in a 9mm case.
96405
The bullets on the left are as cast & the bullets on the right were ran thru a lee .358 sizing die.
These bullets should do extremely well in the 9mm for punching holes in paper along with the 38spl.
We shall see.
forrest r
The bullet has 3 drive bands & a .357 tail, figured the bullet would get swaged down no matter what when it's hollow base is seated deeply in a 9mm case.
96405
The bullets on the left are as cast & the bullets on the right were ran thru a lee .358 sizing die.
These bullets should do extremely well in the 9mm for punching holes in paper along with the 38spl.
We shall see.
forrest r