200gr 7.62x39 Recipe????

[Sidfail]

Hi there, Im fairly new to boolit casting, I was wondering if anybody has a recipe for a subsonic 200gr 7.62 load sitting at approximately 1045-1100ish fps, or at least point me to an apropriate thread, Now being a kiwi in a ruralish place I only have access to ADI powder. This is a load for use in a Chinese bolt action JW103.

Thanks Guys

[supersniper]

My load for the Lyman 314299 was 6.0gr or Titegroup - not sure if that powder has an ADI equivalent.

[HARRYMPOPE]

My 1-12 bolt gun wouldn't stabilize the 314299 at 1600.This was 15 years back and I couldn't get enough powder in the case to make it shoot straight.

[Harter66]

I used IMR 4350 w/a PP'd 200gr boolit in an s k s . Deep seated to fit the magizine w/22.5 and seated to the neck/shoulder junction w/25gr . The top speeds were up about 1500 and 1800 . The real sticker is that the load had to be a full load to burn all the powder. Unique worked well for my naked grease grooved plain based boolit and was nearly all sub sonic loads.

[crackerjack57]

Another re loader that has the Norinco 7.62x39!! Ive got one too and love it!! I was just out at the range on Saturday and I can show you what I was getting with my 185 gn lee mold at 100 yards. also I have attached another pix of what I did with my 155 gn NOE mold. both are gas checked and 50/50 lubed sized to .313 and 2.2" OAL

Here is Saturdays 3 shots circled using Lee 185 grain gas checked and Lubed 50/50 it measures 1 1/4" at 100 y.
96351

Here is a grouping from about 2 months ago using the 155 gn NOE sized at .313 gas checked and lubed 50/50. also at 100 y
96352

sorry but neither of these are sub sonic

I have played with sub sonic a bit and did get my best results with Unique powder. however I was using a 120 gn boolit.