Looking for a mold for a 35 Rem

[hickfu]

I am picking up a 1950 336 in 35 Rem (waffle top) with Ballard rifling, I am looking for a good mold around 200gr.
Some people have said to get the RCBS 35-200 mold but I can only find it in a 2 cavity and only in iron... I am looking for something in aluminum and at least 4 cavity. Any suggestions?


Doc

[white eagle]

RCBS 35-200 mold is a good one
for a custom see any of the many good mold makers
Accurate,MP,Noe Mountain ect.

[shredder]

Check out NOE. I have a 5 banger of the RCBS 200 fn that drops at .360 from them. They are currently in stock for around 100 bucks, great bargain! It is the nicest mould I have.

[hickfu]

Shredder,
Thank you sir... that is exactly what I was looking for!!! now I have to figure out if I should get the GC or PB or both? Maybe the PB and the PatMarlin PB checkmaker? Choices!!

Thanks again,

Doc

[white eagle]

Tom over at Accurate will help you with a custom for your chamber if you want to go that route he also has numerous designs that are in the cal and cav.#'s you seek

[hickfu]

Thanks White Eagle, All of my molds are from Tom but this time I have to go a little cheaper. Too many rifles purchased to quickly and the wifey caught on!!! so I have to hold down the costs for now.

Doc

[35 shooter]

#1 on NOE 200 gr. Shoots great in the 35 whelen slow or fast. I got a 2 cavity gc. mould and wish i had the plain base too in the same mould. Oh well , good excuse to buy another mould from them! The mould pours .3605 to .361 with straight ww depending on pot temp.

[white eagle]

Thanks White Eagle, All of my molds are from Tom but this time I have to go a little cheaper. Too many rifles purchased to quickly and the wifey caught on!!! so I have to hold down the costs for now.

Doc

I hear you on that one