Plain base 22 mold

[Southpaw 72]

Are there any plain base 60-70 gr 22 mold designs out there? Would like one for sub-sonic loads in a 9 twist barrel.

[dkf]

Not that I have seen. Maybe get an MP 65 or 75gr (both drop light) or NOE 70gr rn mold and have the cavities bored out to make it cast PB boolits.

[Southpaw 72]

Not that I have seen. Maybe get an MP 65 or 75gr (both drop light) or NOE 70gr rn mold and have the cavities bored out to make it cast PB boolits.

I thought about that. Just wanted to check and see if their was anything else out there.

[Larry Gibson]

The 225036 and 22536 were made in 40, 46, 54, 60, 69, 75, 84, 90 and 98 gr weights.

Larry Gibson

[Southpaw 72]

The 225036 and 22536 were made in 40, 46, 54, 60, 69, 75, 84, 90 and 98 gr weights.

Larry Gibson

Thanks Larry, that gives me something to search for.

[TCFAN]

I have a 2 cavity made by NEI I bought at least 20 or 25 years ago. It weighs if I remember right around 65 or so grains out of linotype.It is a round nose two lube groove boolit with a crimp groove.Never used it much.Not to accurate out of a 14 inch twist barrel. Does a little better in a 12 inch twist............Terry