Top punch for sizing 358-125-RF to .356?

[dwag]

Rather than getting the best tool for the job, I tend to get a tool that fills a number of uses but none very well. Hence my use of the 358-125-RF which can be sized to .356 for 9mm or "as cast" for .357. The Lyman 429 is recommeded for sizing the .357 but is there a top punch that will work for both?

[ultramag]

Looks like a #429 should work:

http://www.castpics.net/subsite/TopPunches/Lee.html

[dwag]

The #429 will work when sizing to .358 but is the punch diameter too large to use in a .356 sizing die?

[Teddy (punchie)]

send me a PM , I may have one that will work.

[dwag]

PM sent.

Thanks

[myg30]

Your only looking at .002 difference. You can chuck it in a drill and with sandpaper turn the outside down in short order if it was necessary.

just sayin, Mike