AlaskanGuy
12-18-2013, 02:46 PM
Hey all,
I recently got a lyman 429649 mold from a generous member of this board from idaho.... :). I got it casting the way i want now, and the boolit is weighing in at about 340g lubed and checked...
My go to bullet for the 44 mag is the lee 430-310 and this is what i pratice with, and shoot regular.. I am good with it... But i have never shot anything that large before.... Largest was a 320 buffalo load that i used to buy before i started casting myself.. The round will fit fine sized to 310 in my 44...
Does anybody have any experience with this boolit? I was planning to shoot it with ramshot enforcer at 16gr.... I only have a small amount of 2400 left, under a lb, but will be trying that as well....about 16 grains..... I have pleanty of unique but have been advised that it may be a bit much on the pressure side with unique....
Any opinions would be appreciated...
AG
I recently got a lyman 429649 mold from a generous member of this board from idaho.... :). I got it casting the way i want now, and the boolit is weighing in at about 340g lubed and checked...
My go to bullet for the 44 mag is the lee 430-310 and this is what i pratice with, and shoot regular.. I am good with it... But i have never shot anything that large before.... Largest was a 320 buffalo load that i used to buy before i started casting myself.. The round will fit fine sized to 310 in my 44...
Does anybody have any experience with this boolit? I was planning to shoot it with ramshot enforcer at 16gr.... I only have a small amount of 2400 left, under a lb, but will be trying that as well....about 16 grains..... I have pleanty of unique but have been advised that it may be a bit much on the pressure side with unique....
Any opinions would be appreciated...
AG