Steve Steven
12-11-2013, 11:29 PM
I have a CH Autochamp MK IV that I boughtused and have operating fine.
I am interested in putting a Lee bullet feeder on it
90287
I noticed in the Lee instructions that the seater die needs to be shortened and have a chamfered bottom on it to work with the feeder. I am loading .45ACP with CH dies, do you think I could cut the die on the lathe to work?
see page 2 of the instructions
http://leeprecision.com/cgi-data/instruct/BF3498.pdf
Thanks for your thoughts
Steve
I am interested in putting a Lee bullet feeder on it
90287
I noticed in the Lee instructions that the seater die needs to be shortened and have a chamfered bottom on it to work with the feeder. I am loading .45ACP with CH dies, do you think I could cut the die on the lathe to work?
see page 2 of the instructions
http://leeprecision.com/cgi-data/instruct/BF3498.pdf
Thanks for your thoughts
Steve