hylander
11-13-2013, 03:46 PM
So a friend needs some brass for an obsolete cartridge so I'm helping him out.
Just finished the first case and all went better than expected :)
Used my Rong-Fu Mill, would be a lot quicker using a Lathe but alas I do not have a Lathe :(
Made the case on the right from the case on the left
But what is it ?
http://i19.photobucket.com/albums/b193/hylander7/Bows/Goodies/7ec2e94b-da3b-4a86-b743-b2660af8f21e_zps5d2bd70e.jpg
Just finished the first case and all went better than expected :)
Used my Rong-Fu Mill, would be a lot quicker using a Lathe but alas I do not have a Lathe :(
Made the case on the right from the case on the left
But what is it ?
http://i19.photobucket.com/albums/b193/hylander7/Bows/Goodies/7ec2e94b-da3b-4a86-b743-b2660af8f21e_zps5d2bd70e.jpg