View Full Version : New used mold........
mikeym1a
11-10-2013, 11:49 PM
Just got a new to me mold off fleabay. An RCBS 57911, .349GC. I got it for ~$53.00 + shipping. Is this a good price? Midway says a new one is #119. Seems a bit much for a mass produced 2 cavity mold. Any comments? Explanations? Derisions??? :-)
Catshooter
11-11-2013, 12:02 AM
mikey,
RCBS moulds are usually higher than Lyman/Ideals. I'd say you did fine. There's actually quite a few Lymans that are going for more in these trying times.
Cat
mikeym1a
11-11-2013, 12:06 AM
Most of my molds are Lee's, with one or two lyman's. I was looking for a .348 mold and just tapped it in on fleabay, and there it was. I stuck it out and was lucky. Thanks for the reply.
bhn22
11-11-2013, 10:59 AM
You got lucky. That's a special order mold anymore.
mikeym1a
11-11-2013, 05:21 PM
Wow. I almost gave up on it. I had set my limit, and it got close. Thanks!!
RCBS makes great products, and stand behind them with some of the best customer service out there.
Waco
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.