HikerLT
11-10-2013, 11:07 PM
Looking to do some loads for 1895 lever action ( Marlin) 45-70
Using the "LoadBooks" - for 45-70 :
Lyman bullets section ( page 26)
322gr cast bullet ( Actually around 325 gr - the Mihec hollow point with gas check)
all the loads "designate the use of a 1/2 gr Polyester fiber wad, 5/8" square x 1/4" thick over the powder"
I'm planning to do up a load using Unique powder
Question - in place of the 1/4" thick "polyester" 5/8" square they call out to use,
can I use a :
normal 1/8" think, wool felt pad ( 44/45 cal) normally used such as in Ruger Old Army, between the powder and the lead ball ? - and just use 2 of these on top of the powder load ( Unique 12.5 gr) to het the 1/4" thickness ?
example of the nonlubricated wool pads I would like to use :
possibleshop.com- pistolwads
Thanks !
LT
Using the "LoadBooks" - for 45-70 :
Lyman bullets section ( page 26)
322gr cast bullet ( Actually around 325 gr - the Mihec hollow point with gas check)
all the loads "designate the use of a 1/2 gr Polyester fiber wad, 5/8" square x 1/4" thick over the powder"
I'm planning to do up a load using Unique powder
Question - in place of the 1/4" thick "polyester" 5/8" square they call out to use,
can I use a :
normal 1/8" think, wool felt pad ( 44/45 cal) normally used such as in Ruger Old Army, between the powder and the lead ball ? - and just use 2 of these on top of the powder load ( Unique 12.5 gr) to het the 1/4" thickness ?
example of the nonlubricated wool pads I would like to use :
possibleshop.com- pistolwads
Thanks !
LT