DeanWinchester
11-10-2013, 09:23 PM
So, I got this old mold....
An RCBS 30-180-SP. Wouldn't work for me. To fit, I woulda had to seat deeper than like. I don't like putting gas checks below the neck. I've never had any luck when I've tried so my rule is to just not do it. So? What to do?
I stripped the mold down, put it in my drill press and swept an indicator across it. It was in there square, so I took the belt off the drive. Using a press fit 5/16 reamer (.3115) I turned the spindle by hand and GENTLY removed the gas check shank.
A cast, you can just barely see line, but they fall from the mold .312-.3125 and when sized back look perfect. Lubed with Bens Red they weigh 185g now.
Tried them out this morning over 8.0g of Unique in my .308, seated to lightly engrave. 20 shots at 25 yards could be covered with a sliver dollar.
Kind of excited to start working this one up. Going to start scooting up till I reach 12g or so. See where accuracy goes.
Ben's right, these stupid plain base boolits won't shoot fer nuthin'!:kidding:
An RCBS 30-180-SP. Wouldn't work for me. To fit, I woulda had to seat deeper than like. I don't like putting gas checks below the neck. I've never had any luck when I've tried so my rule is to just not do it. So? What to do?
I stripped the mold down, put it in my drill press and swept an indicator across it. It was in there square, so I took the belt off the drive. Using a press fit 5/16 reamer (.3115) I turned the spindle by hand and GENTLY removed the gas check shank.
A cast, you can just barely see line, but they fall from the mold .312-.3125 and when sized back look perfect. Lubed with Bens Red they weigh 185g now.
Tried them out this morning over 8.0g of Unique in my .308, seated to lightly engrave. 20 shots at 25 yards could be covered with a sliver dollar.
Kind of excited to start working this one up. Going to start scooting up till I reach 12g or so. See where accuracy goes.
Ben's right, these stupid plain base boolits won't shoot fer nuthin'!:kidding: