PDA

View Full Version : Scope mount for model 1916 spanish 308


brstevns
11-05-2013, 10:35 PM
Does anyone make a no drill mount for the Spanish Mauser 1916 in 308 ?
tdoor4570
11-06-2013, 12:09 PM
I have got the perfict way to mount a LER handgun scope. a little work is involved but will not change the rifle (no holes ) and can be converted back to org in just a few minutes tdoor4570@bresnan.net we will set up a phone call
Dutchman
11-06-2013, 08:38 PM
The S&K mount for the m/1916 Spanish Mauser is actually one of their better mounts as its very low.

Dutch
Dutchman
11-06-2013, 08:39 PM
I have got the perfict way to mount a LER handgun scope. a little work is involved but will not change the rifle (no holes ) and can be converted back to org in just a few minutes tdoor4570@bresnan.net we will set up a phone call

Why don't you post photos so everybody can see?

Dutch
adrians
11-06-2013, 10:47 PM
Why don't you post photos so everybody can see?

Dutch

+1.
I would like a look-see too..
tdoor4570
11-07-2013, 12:36 PM
Old computer this unit will not support photos, would like to have a new one but can't afford it
brstevns
11-07-2013, 06:31 PM
Old computer this unit will not support photos, would like to have a new one but can't afford it
Can you try and tell us how it is done?
Crytes
11-07-2013, 06:41 PM
got my 1916 Spanish all apart next to me and to scope it without modification I think I'd replace the top handguard panel with a piece with a rail above were the rear sight comes through the original piece. Mine is still a 7mm mauser but was thinking just getting it drilled if I can be confident that stress cracks will not be an issue. Still have a ways to go b4 I'll fire mine tho.
tdoor4570
11-08-2013, 02:42 PM
Guys just send me a pm or an e-mail its easyer to explane than try to type out that way questions can be asked and answers can be given. I will give you my phone # and set up a time best to call tdoor4570@bresnan.net
Green Lizzard
11-09-2013, 12:40 AM
just for load testing on my milsurps i used a spare rear sight (have a box full) grind off the notched part, turn it upside down reinsert the pin drill and tap the sight itself for a flat based marlin mount, for just a few test rounds you can tape the rear of the whole assy down. for long term or permanent use screw it down to the sight base using countersunk screws. with the lighter weight eer scopes or dot sights 2 or 3 screws has all that i ever needed