Psypher
11-04-2013, 08:30 PM
This is a HUGE thank you to the folks that have posted about the Lee aluminum molds and how to get past the headaches. I've had just that headache after the first 50 rounds. I'm now getting swirls and inconsistencies after the first 50 yesterday were great. Not ONE round was able to pass muster today.
Thankfully my RCBS molds came in today so I could run my 9mm rounds while figuring out the "quirks" of the 358 lee molds.
You folks have saved me a considerable amount of money thus far as I was considering a 4 cavity mold and other gear that would have been a massive mistake on my part at this point. I'm going to shy away from the Lee until I get a little more experience with the 358 that I already have.
Thank you very much!
:drinks:
Thankfully my RCBS molds came in today so I could run my 9mm rounds while figuring out the "quirks" of the 358 lee molds.
You folks have saved me a considerable amount of money thus far as I was considering a 4 cavity mold and other gear that would have been a massive mistake on my part at this point. I'm going to shy away from the Lee until I get a little more experience with the 358 that I already have.
Thank you very much!
:drinks: