Who else makes push-through sizer dies?

[Abert Rim]

Lee is offline at least until January. CH4D takes two to three months.
Anyone else make a reasonable push-through size/draw die in custom sizes? I need a .352 die to size down slugs for my .351 Self-Loading Model 1907.

[Dan Cash]

Buckshot, a sponsor of this site, makes a superior push through sizer to your requested dimension. Delivery time is short and price is about the same as an inferior Lee.

[Sgtonory]

why is Lee down?

[Airman Basic]

Buckshot is a member and does that.

[jmort]

why is Lee down?

They are not down, just too much demand to keep up with. They have suspended custom work until January 2014. I believe they will extend the suspension of custom work again, as they have done so from spring 2013 to fall 2013 to January 2104. I doubt they will catch-up in the next two months, but who knows.

[starmac]

Does Buckshot have a website? I didn't see him listed on the vendor sponsor forum. Is there somewhere else to look for sponsors?

[SWANEEDB]

Lee is offline at least until January. CH4D takes two to three months.
Anyone else make a reasonable push-through size/draw die in custom sizes? I need a .352 die to size down slugs for my .351 Self-Loading Model 1907.

I just happen to have a Corbin, never been used, .355 down to .351, will run a PM your way.

[dromia]

Does Buckshot have a website? I didn't see him listed on the vendor sponsor forum. Is there somewhere else to look for sponsors?

Do a search of the member list for Buckshot and PM him.

[Abert Rim]

Gad! I have known Buckshot for a dozen or more years. Did not know this!