View Full Version : Much Thanks to All
FredBuddy
10-13-2013, 01:06 PM
After months of reading hundreds of useful posts here, putting together equipment for smelting and casting (on the cheap), and a few less than satisfactory sessions, I have finally produced the first batch of boolits that would meet your standards.
quilbilly
10-13-2013, 01:23 PM
Welcome to our happy addiction. Hope to hear more from you about your experiences.
FredBuddy
10-13-2013, 01:32 PM
84204
still has a few tricks left.
They look good. Load them up and tell us how they shoot!
MtGun44
10-13-2013, 06:01 PM
Those look nice. Put some of that sticky stuff in the groove and set the LOA to 1.250-1.260,
taper crimp as a separate operation to .465 to .470 at the case mouth and you will be good
to go.
Those are pretty much THE boolit for .45 ACP, although I personally cast the plain base, I
have shot many hundreds of thousands of the BBs from commercial makers.
Bill
btroj
10-13-2013, 07:30 PM
Go put those down range. You did well.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.