dudel
10-13-2013, 01:05 PM
I hadn't seen this written up as a tip, so here goes. The last boolit in the Lee sizer remains there. The Lee provided pusher is not long enough to free it.
So, use a short piece of dowel. Made it as long as the gap between the top of the pusher and the base of the die (with the ram down). Then, on the last boolit, run put the dowel on the pusher, and push the last boolit into the catch box. I used a dowel the size of my smallest boolit. It pushes the largest through as well. I keep the dowel in the box with the sizers.
So, use a short piece of dowel. Made it as long as the gap between the top of the pusher and the base of the die (with the ram down). Then, on the last boolit, run put the dowel on the pusher, and push the last boolit into the catch box. I used a dowel the size of my smallest boolit. It pushes the largest through as well. I keep the dowel in the box with the sizers.