Adhesive for Reloading Press

[Wildcat66]

Need recommendations for a good strong adhesive to use on my reloading press.

I want to attach a led light string on the inside edge so I can make an easier visual
check of the loads on my progressive press.

Thanks.

Nick
West Virginia

[carbine86]

2 ton epoxy should do the trick roigh up the area where you Re putting it as well as use some sand paper on the back of the light strip.

[EDG]

Just Super Glue it if there is little load on the assembly.

Otherwise see if tie wraps will work.

[dbosman]

Gel type super glue.

[KYShooter73]

Nothing wrong with zip ties, won't hurt your press, if the light goes bad, just snip and replace.

[Wildcat66]

After looking at my options the zip tie method is my choice
Have installed it and in the event the light does need replaced
it should be a simple matter

Thanks to everyone for their ideas.....Nick