View Full Version : Adhesive for Reloading Press
Wildcat66
10-03-2013, 03:29 PM
Need recommendations for a good strong adhesive to use on my reloading press.
I want to attach a led light string on the inside edge so I can make an easier visual
check of the loads on my progressive press.
Thanks.
Nick
West Virginia
carbine86
10-03-2013, 03:31 PM
2 ton epoxy should do the trick roigh up the area where you Re putting it as well as use some sand paper on the back of the light strip.
Just Super Glue it if there is little load on the assembly.
Otherwise see if tie wraps will work.
dbosman
10-03-2013, 05:40 PM
Gel type super glue.
KYShooter73
10-03-2013, 10:32 PM
Nothing wrong with zip ties, won't hurt your press, if the light goes bad, just snip and replace.
Wildcat66
10-04-2013, 06:55 AM
After looking at my options the zip tie method is my choice
Have installed it and in the event the light does need replaced
it should be a simple matter
Thanks to everyone for their ideas.....Nick
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.